DidTheyPass
Raleigh and Wake County health inspection record
Food inspection recordWake County Environmental Services

3 - Mobile Food · 27604

Berto's Chimis (Wcid #926)

2411 E Millbrook Rd, Raleigh, NC · (984) 220-2692

PassedSeptember 5, 2026

Did they pass? Yes. Berto's Chimis (Wcid #926) passed its most recent Raleigh health inspection on September 5, 2026.

Inspections, last 12 months
2
Passed
2
Failed
0
Visits with pests noted
0
Facility type
3 - Mobile Food
Record ID
04092030611
Last inspected
September 5, 2026
Data source
Wake County Open Data, Restaurant Inspections

The latest inspection, x-rayed

What the inspector found on September 5, 2026

Every inspection, newest first

  1. September 5, 2026Passed

    Score 94.5, grade A · 1 - Inspection · score 94.5 · grade A

    • Food-contact surfaces: cleaned & sanitized (c) a quaternary ammonium sanitizer shall have a minimum temperature of 75F and a concentration indicated by the manufacturer's directions. P. Quat sanitizer concentration shall be within 150-400ppm. - observed quat sanitizer concentration of less than 150 PPM. Cdi - the quat sanitizer remixed to the 200 PPM. 4-601.11(a) equipment food-contact surfaces and utensils shall be clean to sight and touch. Pf - observed cutting board with grease stain and not clean to the sight or to the touch. Cdi - PIC stated that this prep sink and cutting board are not currently in service. Discussed with PIC that the surface must kept clean. What this means
    • Proper cold holding temperatures (a) (2) and (b) time / temperature control for safety food; hot and cold holding (p) except during preparation; cooking; or cooling; or when tphc is used TCS food shall be maintained at 41F or less. P - observed prep cooler: commercially prepared chopped lettuce( 50F) with temperature above 41F. Cdi - the chopped lettuce was returned to the standing cooler to cool it down. What this means
    • Thermometers provided & accurate Temperature measuring devices; ambient air and water-accuracy (b) ambient air and water temperature measuring devices that are scaled only in fahrenheit shall be accurate to ±3F in the intended range of use. Pf - observed prep cooler with no ambient air thermometer. Verification due by 9/15/26 What this means
    • Equipment; food & non-food contact surfaces approved; cleanable; properly designed; constructed & used Good repair and proper adjustment - equipment (c) - observed hood lights not functioning. What this means
    • Warewashing facilities: installed; maintained & used; test strips A test kit or other device that accurately measures the concentration in mg/l of sanitizing solutions shall be provided. Pf - observed a quat test strip with faded color that can no longer accurately detect concentration. Verification of test strip replacement due by 9/15/26 What this means
    • Non-food contact surfaces clean Nonfood contact surfaces of equipment shall be cleaned at a frequency necessary to preclude accumulation of soil residues. - observed grease accumulation on the prep sink; prep table; shelf; and fryer that needs to be cleaned. Discussed the matter with PIC. What this means
    • Physical facilities installed; maintained & clean Cleaning; frequency and restrictions(a)physical facilities shall be cleaned as often as necessary to keep them clean. - observed black stain/grease accumulation on the floor throughout and at the floor corner near the standing cooler that needs to be cleaned. Also; grease on the wall. Discussed the matter with PIC. What this means
    • Meets ventilation & lighting requirements; designated areas used Provide sufficient ventilation to keep rooms free of excessive heat; steam; condensation; vapors; obnoxious odors; smoke; and fumes. - observed inadequate pressure on the hood that need to be adjust due to grease accumulation inside the mobile food unit. Discussed the matter with PIC. What this means
  2. December 3, 2025Passed

    Score 97.5, grade A · 1 - Inspection · score 97.5 · grade A

    • Handwashing sinks supplied & accessible Handwashing sink out of soap. Each handwashing sink shall be provided with a supply of hand cleaning liquid; powder; or bar soap. Cdi- soap added during inspection. What this means
    • Thermometers provided & accurate Air temperature thermometer not available in the prep cold-hold unit. In a mechanically refrigerated food storage unit; the sensor of a temperature measuring device shall be located to measure the air temperature in the warmest part of a mechanically refrigerated unit. Add an air temperature thermometer to this unit. What this means
    • Non-food contact surfaces clean (b) and (c); core; grease and debris residue accumulation on equipment throughout mfu. Heavy char accumulation on countertop grill unit. Nonfood-contact surfaces of equipment shall be kept free of an accumulation of dust; dirt; food residue; and other debris. Increase cleaning frequency to these areas. [repeat] What this means
    • Physical facilities installed; maintained & clean Greasy residue accumulation along floors/walls/ceiling throughout mfu. Physical facilities shall be cleaned as often as necessary to keep them clean. Increase cleaning frequency to these areas and clean thoroughly. [repeat] What this means
    • Meets ventilation & lighting requirements; designated areas used Lights over grill not working and lighting for this area not bright enough. Maintain lighting to at least 540 lux (50 foot candles) at a surface where a food employee is working with food or working with utensils or equipment such as knives; slicers; grinders; or saws where employee safety is a factor. Repair lights to increase lighting to this area.

From the Wake County Environmental Services, published as Wake County Open Data, Restaurant Inspections. Text is the inspector's, shortened only for length. North Carolina scores each inspection out of 100. Here, 90 or above (grade A) counts as passed, 80 to 89.5 (grade B) as passed with conditions, and below 80 (grade C or lower) as failed. Priority items and CDC risk factors are listed as serious.

Questions

Did Berto's Chimis (Wcid #926) pass its health inspection?

Yes. Berto's Chimis (Wcid #926) passed its most recent Raleigh health inspection on September 5, 2026.

How many times was Berto's Chimis (Wcid #926) inspected in the last year?

2 times in the last 12 months, with 0 failed results.

Who inspects Berto's Chimis (Wcid #926)?

The Wake County Environmental Services. North Carolina scores each inspection out of 100. Here, 90 or above (grade A) counts as passed, 80 to 89.5 (grade B) as passed with conditions, and below 80 (grade C or lower) as failed. Priority items and CDC risk factors are listed as serious.