North Carolina health inspection recordRestaurant · 28303
Continental Cafe
808 Elm St, Fayetteville, NC
Did they pass? Yes. Continental Cafe passed its most recent North Carolina health inspection on October 30, 2026.
- Inspections, last 12 months
- 3
- Passed
- 3
- Failed
- 0
- Visits with pests noted
- 0
- Facility type
- Restaurant
- Record ID
- 5026010943
- Last inspected
- October 30, 2026
The latest inspection, x-rayed
What the inspector found on October 30, 2026
Every inspection, newest first
-
October 30, 2026Passed
- SeriousToxic substances properly identified stored & used 7-204.11 sanitizers, criteria - chemicals (p) sanitizing solutions stored in red sanitizing buckets were measured at 2,000 PPM, which is above the acceptable concentration for food-contact surface sanitizing solutions. Sanitizing solutions in the red buckets were diluted and rechecked, measuring 50 PPM. Corrected during inspection (cdi) 7-207.11 restriction and storage - medicines (p) (pf) medicines were observed stored above a microwave located on a prep table in front of the cooking equipment. The medicines were removed and placed in the employee storage cabinet. Cdi Corrected during the inspection. What this means
- Utensils, equipment & linens: properly stored, dried & handled 4-903.11 (a), (b), and (d) equipment, utensils, linens and single-service and single-use articles storing (c) dishes were observed wet-stacked underneath the main kitchen prep table. Rehs demonstrated to staff the proper method for storing and staggering dishes to allow adequate drainage and air drying. Rehs also advised management to ensure staff use shelving with openings that allow water to drain properly, rather than storing dishes on the solid shelf underneath the main prep table, where water collects and is unable to drain. What this means
- Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used Comment 4-501.11 good repair and proper adjustment - equipment (c) the kitchen single-door reach-in cooler was observed to be out of service. All food normally stored in the unit had been relocated to the kitchen prep unit. No food was observed stored inside the single-door reach-in cooler at the time of inspection. Management stated that a replacement reach-in cooler had been ordered and that the establishment was awaiting delivery. The dishmachine sanitizer dispensing mechanism was also observed to be operating inconsistently. During the initial testing of the dishmachine, sanitizer was not being drawn and dispensed into the warewashing machine. The warewashing employee stated that the unit had been primed and tested every 20 minutes due to the inconsistent sanitizer dispensing. Management and warewashing staff stated that replacement parts for the dishmachine's sanitizer dispensing mechanism had been ordered and were scheduled to be delivered and installed the following day, 10/31/2026. What this means
- Warewashing facilities: installed, maintained & used; test strips 4-501.16 warewashing sinks, use limitation (c) flounder was observed thawing in the two-compartment warewashing sink while wash water used for soaking dishes was being stored in the wash vat of the same sink. The sink may be used for either activity; however, it must be cleaned and sanitized as required before and after thawing food or washing produce. Warewashing staff drained the dish-soaking water and continued thawing the flounder. After the flounder was completely thawed, the two-compartment sink was observed to be cleaned. Cdi Corrected during the inspection. What this means
- Non-food contact surfaces clean Comment 4-601.11 (b) and (c) equipment, food-contact surfaces, nonfood contact surfaces, and utensils (c) the interior of the kitchen oven was observed to be soiled with accumulated of buildup. The door gaskets of the two-door reach-in freezer were also observed to be soiled with black buildup. Food-contact surfaces of cooking equipment and pans must be kept free of encrusted grease deposits and other soil accumulations. Repeat (Repeat finding.) What this means
- Plumbing installed; proper backflow devices Comment 5-205.15 (b) system maintained in good repair a leak was observed at the base of the faucet of the two-compartment sink. Repeat (Repeat finding.) What this means
- Physical facilities installed, maintained & clean 6-501.11 repairing - premises, structures, attachments, and fixtures - methods (c) wallpaper in the men's restroom was observed to be in poor repair. The wall covering along the walkway leading to the rear kitchen exit door was also observed to be damaged. Booth cushions and bar chairs throughout the dining area were observed to be torn and in poor repair. Additionally, a light fixture located above the kitchen prep table was observed to be nonfunctional, and paint above the clean dish drainboard was observed to be cracking. Repeat. (Repeat finding.) What this means
- Meets ventilation & lighting requirements; designated areas used 6-303.11 intensity - lighting (c) lighting throughout the establishment was observed to be insufficient in multiple areas, including, but not limited to, the hallway two-door reach-in freezer and ice machine area, hood system area, drainboards of the warewashing machine, baker's table, and meat cutter area. A minimum light intensity of 20 foot-candles is required inside equipment, such as reach-in refrigerators, measured at a distance of 30 inches above the floor in areas used for handwashing, warewashing, equipment and utensil storage, and in toilet rooms. A minimum light intensity of 50 foot-candles is required at work surfaces where food employees handle food or use equipment such as knives, slicers, grinders, or saws, where employee safety is a factor. Rehs highly recommends upgrading existing lighting to led fixtures to improve illumination throughout the establishment. Refer to the temperature chart for specific lighting measurements and details. Repeat. (Repeat finding.) What this means
-
June 23, 2026Passed
- SeriousHands clean & properly washed 2-301.15 where to wash (pf) an employee was observed washing hands in the wash water at the 2-compartment sink after skinning potatoes, then rinsing hands in the sanitizing basin of the same sink. The employee was made aware of proper handwashing procedures and was redirected to perform handwashing at the designated kitchen handwashing sink. Corrected during inspection (cdi). What this means
- SeriousFood-contact surfaces: cleaned & sanitized 4-601.11 (a) equipment, food-contact surfaces, nonfood contact surfaces, and utensils (pf) food debris, including food splash and accumulated residue, was observed inside metal food storage containers stored under the main prep table in the kitchen. The registered environmental health specialist (rehs) informed staff that debris from food preparation activities conducted above the storage area has the potential to fall into and onto clean dishes stored underneath the table. Staff were advised to relocate dishes to the opposite side of the prep area to prevent overhead contamination. Additionally, food debris was observed on the food-contact surface of side cups stored above the steam table. Buildup was also noted on the bottom of the pusher arm attached to the meat slicer. The soiled dishes and utensils were cleaned and sanitized during the inspection. Corrected during inspection (cdi). Corrected during the inspection. What this means
- Proper cooling methods used; adequate equipment for temperature control 3-501.15 cooling methods (pf) oatmeal (112°F), grits (99°F), and sausage gravy (119°F) were observed sitting on a kitchen prep table. Per the owner, prior to the inspection these TCS stands for time/temperature control for safety (TCS) food items were removed from the steam table after breakfast service, placed into food storage containers, covered, and stored on a prep table for cooling. Other TCS food items stored in a single-door reach-in cooler were also observed to be covered during the cooling process. TCS food items were observed uncovered and relocated into other refrigeration units to ensure proper cooling. The registered environmental health specialist (rehs) will return to verify proper cold holding and cooling parameters are maintained. Note: cooling begins at 135°F and must be monitored using an accurate food thermometer. TCS foods must be cooled from 135°F to 70°F within 2 hours, and from 70°F to 41°F within an additional 4 hours, for a total cooling time of 6 hours. If food does not reach 70°F within the first 2 hours, it must be discarded. It was noted that refrigeration performance was impacted due to the cooler door being left open while storing delivered shelled What this means
- In-use utensils: properly stored Comment 3-304.12 in-use utensils, between-use storage (c) small portion cups were observed stored inside ground coffee containers.
- Non-food contact surfaces clean Comment 4-601.11 (b) and (c) equipment, food-contact surfaces, nonfood contact surfaces, and utensils (c) the bottom portion of the steam table was observed to be soiled with accumulated food debris and residue. The interior of the kitchen oven was also observed to be soiled with buildup. Food-contact surfaces of cooking equipment and pans must be kept free of encrusted grease deposits and other soil accumulations. Repeat (Repeat finding.) What this means
- Plumbing installed; proper backflow devices Comment 5-205.15 (b) system maintained in good repair a leak was observed beneath the cold water knob of the handwashing sink, as well as beneath the base of the faucet of the two-compartment sink. What this means
- Physical facilities installed, maintained & clean 6-501.11 repairing - premises, structures, attachments, and fixtures - methods (c) bubbled paint was observed along the wall behind the clean dish drainboard connected to the dish machine. Additionally, wallpaper in the men’s restroom and in the walkway leading to the back kitchen exit door was observed to be damaged. Booth cushions and bar chairs throughout the dining area were observed torn and in poor repair. A light fixture located above the kitchen prep table was also observed to be nonfunctional. Per the owner, the bulb was recently replaced; however, the light remains inoperable due to a suspected electrical or fixture issue. Repeat 6-501.12 cleaning, frequency and restrictions (c) restroom fan guards attached to the ceiling were observed to be heavily accumulated with dust. (Repeat finding.) What this means
- Meets ventilation & lighting requirements; designated areas used 6-303.11 intensity - lighting (c) lighting throughout the establishment was observed to be insufficient in multiple areas, including but not limited to the hallway two-door reach-in freezer and ice maker area, hood system area, restroom toilets and handwashing sinks, soiled-side drainboard of the warewashing machine, baker’s table, and meat cutter area. The registered environmental health specialist (rehs) highly recommends upgrading existing lighting to led fixtures to improve illumination throughout the establishment. A minimum of 20 foot-candles of light intensity is required: inside equipment such as reach-in refrigerators at a distance of 30 inches above the floor in areas used for handwashing, warewashing, equipment and utensil storage, and in toilet rooms a minimum of 50 foot-candles of light intensity is required: at work surfaces where food employees are handling food or using equipment such as knives, slicers, grinders, or saws, where employee safety is a factor. Repeat 6-403.11 designated areas - employee accommodations for eating / drinking / smoking (c) an employee beverage was observed stored on a shelf above to-go containers. (Repeat finding.) What this means
-
February 10, 2026Passed
- Contamination prevented during food preparation, storage & display Comment 3-307.11 miscellaneous sources of contamination (c) a two-door reach-in freezer and a large ice maker were observed stored in the walkway in front of the restrooms, which were unsecured and accessible to the public. To ensure food protection, ehs recommended installing barriers and/or locking the two-door reach-in freezer and large ice maker so they are accessible only to employees and not the public.
- Equipment, food & non-food contact surfaces approved, cleanable, properly designed, constructed & used 4-501.11 good repair and proper adjustment - equipment (c) the beverage cooler was observed maintaining an ambient temperature of 48°F. Milk was observed stored in the unit and was relocated to another cooler to properly cool. What this means
- Non-food contact surfaces clean 4-601.11 (b) and (c) equipment, food-contact surfaces, nonfood contact surfaces, and utensils (c) blood was observed on the bottom of the two-door reach-in cooler in the kitchen area. The blood from the beef logs was not observed contaminating any other food items within the unit. Tracks on the bread drawer(s) were observed soiled. Food-contact surfaces of cooking equipment and pans must be kept free of encrusted grease deposits and other soil accumulations. What this means
- Physical facilities installed, maintained & clean 6-501.11 repairing - premises, structures, attachments, and fixtures - methods (c) damaged floor tiles were observed underneath the two-compartment sink. Per the owner, a work order has been placed and service is pending. Paint was observed peeling along the wall behind the clean dish drainboard connected to the dish machine. Wallpaper above the restrooms was observed separating from the wall. Booth cushions were observed in poor repair. Repeat (Repeat finding.) What this means
- Meets ventilation & lighting requirements; designated areas used A minimum of 20 foot-candles of light intensity is required: inside equipment such as reach-in refrigerators at a distance of 30 inches above the floor in areas used for handwashing, warewashing, equipment and utensil storage, and in toilet rooms a minimum of 50 foot-candles of light intensity is required: at work surfaces where food employees are handling food or using equipment such as knives, slicers, grinders, or saws, where employee safety is a factor. Repeat (Repeat finding.) What this means
From the North Carolina county environmental health offices, published as North Carolina environmental health public inspections portal. Text is the inspector's, shortened only for length. North Carolina scores food places out of 100: A is 90 or more, B is 80 to 89.5, C is 70 to 79.5, and below 70 the permit is pulled. Here, an A counts as passed, a B or C as passed with conditions, and below 70 as failed. Child care centers and some other places get no grade; for those, an inspection with items cited counts as passed with conditions. Items 1 to 29 are the foodborne illness risk factors and are listed as serious.
Questions
Did Continental Cafe pass its health inspection?
Yes. Continental Cafe passed its most recent North Carolina health inspection on October 30, 2026.
How many times was Continental Cafe inspected in the last year?
3 times in the last 12 months, with 0 failed results.
Who inspects Continental Cafe?
The North Carolina county environmental health offices. North Carolina scores food places out of 100: A is 90 or more, B is 80 to 89.5, C is 70 to 79.5, and below 70 the permit is pulled. Here, an A counts as passed, a B or C as passed with conditions, and below 70 as failed. Child care centers and some other places get no grade; for those, an inspection with items cited counts as passed with conditions. Items 1 to 29 are the foodborne illness risk factors and are listed as serious.