DidTheyPass
Minneapolis health inspection record
Food inspection recordMinneapolis Health Department, Environmental Health

Restaurant · 55408

Moto I

2940 Lyndale Ave S, Lowry Hill East, MN

ConditionalSeptember 30, 2026

Did they pass? Yes, with conditions. Moto I's most recent Minneapolis health inspection, on September 30, 2026, was marked "12 items cited".

Inspections, last 12 months
1
Passed
1
Failed
0
Visits with pests noted
0
Facility type
Restaurant
Record ID
LIC37083
Last inspected
September 30, 2026
Data source
City of Minneapolis open data, Food Inspections

The latest inspection, x-rayed

What the inspector found on September 30, 2026

Every inspection, newest first

  1. September 30, 2026Conditional

    12 items cited · Routine

    • Keep the physical facilities in good repair. Tile flooring in multiple areas has chipped away, baseboard tile is pulling away from the wall, and grout lines have eroded. Repair or replace floor finishes where needed. What this means
    • Floors, walls and/or ceiling finishes are not approved. Finishes must be smooth and easily cleanable. The area around the bag-in-box setup downstairs and the upright cooler is not finished. Properly finish the space around these areas. Consult the inspector as needed. What this means
    • Keep at each handwashing sink or group of adjacent handwashing sinks one of: • a supply of disposable towels • a continuous towel system • an approved air temperature hand drying device The hand sink near the dish area was not stocked with paper towels. The dispenser was stocked during the inspection. Corrected during the inspection. What this means
    • Place fixed equipment to allow access for cleaning or, seal to adjoining equipment or walls. The hand sink splash guard at the sink near the fry station is coming away from the sink itself, making the sink difficult to clean. Re-seal this splash guard to the sink. What this means
    • Clean non-food contact surfaces of equipment. Keep them clean. The shelf above the cooktop and the fan facing the line are both soiled with debris buildup and/or dust buildup. Clean and maintain all non-food-contact surfaces. What this means
    • Store in-use food preparation and serving utensils only on clean, sanitized surfaces. Tongs were stored on the oven handle during the shift. Move in-use utensils to a location where they won't be contaminated. What this means
    • Make sure light fixtures have light shields or shatter-resistant light bulbs in areas with: • exposed food • clean equipment and utensils • clean linens • unwrapped single-service items The light shield in the walk-in cooler upstairs is cracked, exposing the light bulbs themselves. Replace the shield.
    • Store all clean equipment, utensils, linens, in a clean dry location where not exposed to splash, dust, or other contamination and at least six inches above the floor. Clean and frozen ice wands were stored directly on the shelf in the upright freezer downstairs. Wrap these wands once ready to use, or store them in a container that will be washed, rinsed, and sanitized. What this means
    • Have at least 10-foot candles of light intensity at a distance of 30 inches from the floor in: • walk-in refrigeration units • dry food storage areas • in other areas while being cleaned Both the brew area walk-in coolers and the basement have insufficient lighting. Fix the current lighting and/or increase the light intensity in these units. What this means
    • Equipment food-contact surfaces and utensils must be clean. The wall dicing block was soiled with food debris buildup. This equipment was cleaned and sanitized during the inspection. Ensure that all food-contact surfaces are kept clean. Corrected during the inspection. What this means
    • SeriousHave an approved chlorine chemical sanitizer solution. The solution must have a minimum concentration of 50 PPM. The solution must also meet the temperature and ph requirements of this rule. The dish machine sanitizer concentration in the bar was not within an approved range during the inspection. The person in charge primed the machine during the inspection until the concentration was appropriate. Ensure that the concentration of sanitizers is maintained within an approved range. Corrected during the inspection. What this means
    • All equipment and components must be in good repair. Keep them maintained to manufacturer's specifications. The shelving in the upright cooler downstairs is corroded. Refinish or replace the shelves.

From the Minneapolis Health Department, Environmental Health, published as City of Minneapolis open data, Food Inspections. Text is the inspector's, shortened only for length. Minneapolis does not give a grade or a pass or fail. Here, an inspection with no items cited counts as passed, and one with items cited counts as passed with conditions. Items the city marks Priority 1 are listed as serious.

Questions

Did Moto I pass its health inspection?

Yes, with conditions. Moto I's most recent Minneapolis health inspection, on September 30, 2026, was marked "12 items cited".

How many times was Moto I inspected in the last year?

1 time in the last 12 months, with 0 failed results.

Who inspects Moto I?

The Minneapolis Health Department, Environmental Health. Minneapolis does not give a grade or a pass or fail. Here, an inspection with no items cited counts as passed, and one with items cited counts as passed with conditions. Items the city marks Priority 1 are listed as serious.